A
ahmed_seedat
Guest
I have a database that writes a lot of data to AI and this is code related as we know about this. This morning we had the issue where the DB went into stall because the /aibackup area where we write the full AI's out was full. We have a restart on the DB daily at 05:00 and when the DB was shut down we were unable to start it. We cleared the AI Backup area and tried restarting the DB. This did not work. We then disabled replication and AI and re-enabled AI and replication.We busy with a backup so that we can sync the replicated DB's. We have 2 targets on this DB. The Question is as follows: Is there a command to run to clear the full AI files before trying to start the DB after a stall.?
Continue reading...
Continue reading...