Progress 9.1B
HP-UX 11.i
When I run the UNIX statement from within the Procedure Editor it brings me out to the unix prompt but there is just a cursor flashing.
On another system when I run the command I get $$.
Is there a setting that I have to set to get the $$?
Thanks
Michelle Keough
HP-UX 11.i
When I run the UNIX statement from within the Procedure Editor it brings me out to the unix prompt but there is just a cursor flashing.
On another system when I run the command I get $$.
Is there a setting that I have to set to get the $$?
Thanks
Michelle Keough